Toyota Camry owners & service manuals

Toyota Camry (XV70): Indicator does not Illuminate

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System (for Manual Air Conditioning System) / Indicator does not Illuminate

DESCRIPTION

If none of the switch indicators on the air conditioning control assembly illuminate, the following suspected areas may be the cause.

Symptom

Factor

None of the switch indicators on the air conditioning control assembly illuminate
  • Air conditioning amplifier assembly malfunction
  • Air conditioning control assembly malfunction
  • A/C switch malfunction
  • A/C switch indicator malfunction (including when indicator turned off without switch operation)
  • Servo motor initialization (incomplete)
  • Mechanical locking of damper and damper link
  • Refrigerant pressure is extremely low
  • Low detected ambient temperature (including thermistor assembly malfunction)

PROCEDURE

1.

CHECK AIR CONDITIONING CONTROL ASSEMBLY

(a) Check that the switch indicators on the air conditioning control assembly illuminate immediately after the engine is started.

OK:

All switch indicators illuminate.

NG

REPLACE AIR CONDITIONING CONTROL ASSEMBLY

OK

2.

READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air Conditioner / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Air Conditioner > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Ambient Temp Sensor

Thermistor assembly

Min.: -23.30°C (-9.94°F)

Max.: 65.95°C (150.71°F)

Actual ambient temperature displayed

-
Body Electrical > Air Conditioner > Data List

Tester Display

Ambient Temp Sensor

OK:

The value displayed is 0°C (32°F) or higher.

OK

INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET

NG

GO TO OTHER DIAGNOSIS PROCEDURE (Ambient Temperature Display System)

    READ NEXT:

     Cooling System

    DESCRIPTION If the cooling effect of the air conditioning system is weak, the following suspected areas may be the cause. Symptom Factor Cooling effectiveness is poor Cooling res

     Operation not Accepted Even If Air Conditioning Switch is Operated

    DESCRIPTION If the air conditioning system cannot be operated using the air conditioning control assembly, the following suspected areas may be the cause. Symptom Factor Air conditioning

     Front Window Fogging

    DESCRIPTION If the windshield frequently fogs up even though the air conditioning system is operating, the following suspected areas may be the cause. Symptom Factor Windshield frequentl

    SEE MORE:

     Washer fluid

    Add washer fluid in the following situations: A washer does not work. "Windshield Washer Fluid Low" is displayed on the multi-information display. WARNING ■When adding washer fluid Do not add washer fluid when the engine is hot or running as washer fluid contains alcohol and may

     Replacement

    REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below. Necessary Procedures After Parts Removed/In

    © 2023-2026 Copyright www.tocamry.com