Toyota Camry (XV70): Inspection
INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Ensure that fingers or articles of clothing do not get caught in moving parts when performing this test.
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
| (a) Check the HI operation. (1) Connect a positive (+) lead from the battery to terminal 4 (+B) and a negative (-) lead to terminal 1 (GND) and 3 (2S), and check that the windshield wiper motor assembly operates. NOTICE: Be careful not to get your fingers pinched between the parts shown in the illustration when the wiper motor and link assembly is operating. OK: Windshield wiper motor assembly operates at high speed (HI). If the result is not as specified, replace the windshield wiper motor assembly. |
|
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT
NOTICE: Make sure to hold the front wiper arm while lifting it as lifting the front wiper arm by the front wiper blade may damage or deform the front wiper blad
Front Wiper Rubber
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT WIPER BLADE
*2 WIPER RUBBER
*3 FRONT WIPER RUBBER BACKING PLATE
- - ReplacementREPLACEMENT CAUTION / NOTICE /
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT WIPER RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester
SEE MORE:
Fuel Tank Cap
InspectionINSPECTION PROCEDURE
1. INSPECT FUEL TANK CAP ASSEMBLY
(a) Visually check that the fuel tank cap assembly and gasket are not deformed or damaged.
If the result is not as specified, replace the fuel tank cap assembly.
*a Gasket
(b)
Open in Bus 1 Main Bus Line
DESCRIPTION There may be an open circuit in one of the CAN main bus lines when the resistance between terminals 23 (CA1H) and 8 (CA1L) of the central gateway ECU (network gateway ECU) is 70 Ω or higher.
Symptom Trouble Area
Resistance between terminals 23 (CA1H) and 8 (CA1L) of
