Toyota Camry (XV70): Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WIPER RELAY
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the WIPER relay. |
|
2. INSPECT WASHER RELAY
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the WASHER relay. |
|
READ NEXT:
Washer Level Warning Switch
ComponentsCOMPONENTS ILLUSTRATION
*1 LEVEL WARNING SWITCH ASSEMBLY
- - RemovalREMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initializ
Washer Motor
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT FENDER LINER RH
*2 FRONT WHEEL OPENING EXTENSION PAD RH
*3 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
- - Remov
Washer Nozzle
ComponentsCOMPONENTS ILLUSTRATION
*1 WASHER NOZZLE SUB-ASSEMBLY
- -
● Non-reusable part
- - On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
SEE MORE:
Software Incompatibility with Body Control Module "B" (U1331)
DESCRIPTION This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors. Blind Spot Monitor Master
DTC No. Detection Item
DTC Detection Condition Trouble Area
U1331 Software Incom
Right Rear Wheel Speed Sensor Circuit Short to Ground or Open (C051214)
DESCRIPTION Refer to DTC C051212 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C051214 Right Rear Wheel Speed Sensor Circuit Short to Ground or Open
A short or open circuit is detected in the speed sensor signal circuit for 0.12 seconds or
