Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL REAR SPEAKER ASSEMBLY

NOTICE:

Do not touch the speaker cone.

(a) Connect the connector.

(b) Engage the 2 guides to temporarily install the rear speaker assembly.

(c) Install the rear speaker assembly with the 3 screws.

*A

for LH Side

*B

for RH Side

HINT:

Install the screws in the order shown in the illustration.

2. INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER

Click here

3. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Click here

4. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here

5. INSTALL REAR ARMREST ASSEMBLY

Click here

6. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Click here

7. INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY

Click here

8. INSPECT POWER WINDOW OPERATION

Click here

    READ NEXT:

     Rear Package Tray Speaker

     Components

    COMPONENTS ILLUSTRATION *1 REAR DOOR OPENING TRIM WEATHERSTRIP LH *2 REAR DOOR OPENING TRIM WEATHERSTRIP RH *3 REAR SEAT CUSHION ASSEMBLY *4 REAR SEAT CUSHION LOC

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r

    SEE MORE:

     Lost Communication with Sliding Sunshade ECU (B2329)

    DESCRIPTION This DTC is stored when LIN communication between the roof sunshade ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B2329 Lost Communic

     Terminals Of Ecu

    TERMINALS OF ECU NOTICE: DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed. Do not apply excessive force to the forward recognition camera connector. *A Be

    © 2023-2026 Copyright www.tocamry.com