Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY (except Panoramic Moon Roof)
(a) When reusing the telephone and GPS antenna assembly:
(1) Install a new seal.
(b) Push the telephone and GPS antenna assembly in the direction indicated by the arrow (1) shown in the illustration to engage the guide.
.png)
.png) |
Install in this Direction (1) |
.png) |
Install in this Direction (2) |
(c) Push the telephone and GPS antenna assembly in the direction indicated by the arrow (2) shown in the illustration to engage the 2 guides and 3 claws and install the telephone and GPS antenna assembly.
2. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY WITH COVER (except Panoramic Moon Roof)
(a) Install a new washer and holder as shown in the illustration.
.png)
|
|
Install in this Direction |
(b) Install the telephone and GPS antenna assembly with cover with the bolt.
Torque:
9.5 N
READ NEXT:
Telephone And Gps Antenna Cords (for Front Side)
ComponentsCOMPONENTS ILLUSTRATION
*1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
*2 NO. 2 SIDE DEFROSTER NOZZLE DUCT
*3 NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
*4
Telephone And Gps Antenna Cords (for Roof Side)
ComponentsCOMPONENTS ILLUSTRATION
*1 TELEPHONE AND GPS ANTENNA CORD
- - RemovalREMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initializatio
SEE MORE:
Brake Hold
The brake hold system keeps the brake applied when the shift
lever is in D, S or N with the system on and the brake pedal has
been depressed to stop the vehicle. The system releases the
brake when the accelerator pedal is depressed with the shift
lever in D or S to allow smooth start off.
Turns
System Diagram
SYSTEM DIAGRAM
Transmitting ECU (Transmitter)
Receiving ECU Signal
Communication Method
Skid control ECU (brake actuator assembly)
Steering angle sensor Steering angle sensor request signal
CAN communication line
Steering angle sensor
