Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
- Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
- After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR DISC
| (a) Align the matchmarks of the rear disc and rear axle hub and bearing assembly, and install the rear disc. NOTICE: When replacing the rear disc with a new one, select the installation position where the rear disc has minimal runout. |
|
.png)
2. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
(a) Install the parking brake shoe adjusting hole plug to the rear disc.
3. INSTALL REAR DISC BRAKE CYLINDER MOUNTING
(a) Install the rear disc brake cylinder mounting to the rear axle carrier sub-assembly with the 2 bolts.
Torque:
107 N
READ NEXT:
Rear Brake Flexible Hose(w/ Electric Parking Brake System)
ComponentsCOMPONENTS ILLUSTRATION
*1 REAR FLEXIBLE HOSE
*2 GASKET
*3 UNION BOLT
*4 BRAKE LINE
Tightening torque for "Major areas involving basic ve
Rear Brake Flexible Hose(w/o Electric Parking Brake System)
ComponentsCOMPONENTS ILLUSTRATION
*1 REAR FLEXIBLE HOSE
*2 GASKET
*3 UNION BOLT
- -
Tightening torque for "Major areas involving basic vehicle perf
Rear Disc Brake Pad(w/ Electric Parking Brake System)
ComponentsCOMPONENTS ILLUSTRATION
*1 NO. 2 PARKING BRAKE WIRE ASSEMBLY
*2 REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
*3 REAR DISC BRAKE PAD
*4 REAR DISC BRAKE CYLINDER
SEE MORE:
Check Bus 3 Lines for Short Circuit
DESCRIPTION There may be a short circuit between the CAN main bus lines and/or CAN branch lines when the resistance between terminals 6 (CA3H) and 21 (CA3L) of the central gateway ECU (network gateway ECU) is below 54 Ω.
Symptom Trouble Area
Resistance between terminals 6 (CA3H)
Display does not Dim when Light Control Switch is Turned ON
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio and display
© 2023-2026 Copyright www.tocamry.com
