Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
w/ Electric Parking Brake System:HINT:
The parking brake indicator light blinks (red) when the engine switch is turned on after replacing the brake actuator assembly. Operate the electric parking brake switch assembly to turn off the parking brake indicator light.
PROCEDURE
1. INSTALL BRAKE ACTUATOR BRACKET CUSHION
HINT:
Perform this procedure only when replacement of the brake actuator bracket cushions is necessary.
(a) Install the 3 brake actuator bracket cushions to the brake actuator bracket assembly.
2. INSTALL NO. 2 BRAKE ACTUATOR CASE COLLAR
HINT:
Perform this procedure only when replacement of the No. 2 brake actuator case collars is necessary.
(a) Install the 3 No. 2 brake actuator case collars to the brake actuator bracket cushion.
NOTICE:
Make sure that the No. 2 brake actuator case collar is in full contact with the brake actuator bracket cushion.
(b) Install the 3 nuts.
Torque:
19 N
READ NEXT:
Brake Hold Switch
ComponentsCOMPONENTS ILLUSTRATION
*1 BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
- - RemovalREMOVAL PROCEDURE
1. PRECAUTION Click here
2. REMOVE REAR UPPER
Components
COMPONENTS ILLUSTRATION
*1 FRONT FENDER LINER
*2 FRONT SPEED SENSOR
*3 FRONT WHEEL OPENING EXTENSION PAD
*4 FRONT FLEXIBLE HOSE
Tightening torque f
SEE MORE:
GPS Antenna Connection Malfunction(short) (B15C0,B15C1)
DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
DTC No. Detection Item
DTC Detection Condition Trouble Area
B15C0 GPS Antenna Connection Malfunction(short)
Navigation antenna malfunction
Navigation antenna asse
Check Bus 3 Line for Short to +B
DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and termin
