Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Axle And Differential / Rear Axle Hub (for 2wd Without Electric Parking Brake System) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:

90 N

    READ NEXT:

     Rear Axle Hub (for Awd)

     Components

    COMPONENTS ILLUSTRATION *1 NO. 2 PARKING BRAKE WIRE ASSEMBLY *2 REAR AXLE HUB AND BEARING ASSEMBLY *3 REAR AXLE SHAFT NUT *4 REAR DISC *5 REAR DISC BRAK

     On-vehicle Inspection

    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL Click h

    SEE MORE:

     Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure (P010064)

    DESCRIPTION Refer to DTC P010012. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P010064 Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure All of the following conditions are met (2 trip detection log

     Initialization

    INITIALIZATION INITIALIZATION SERVO MOTOR (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Press the OFF switch. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization. (f) According to the

    © 2023-2026 Copyright www.tocamry.com