Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR DIFFERENTIAL SUPPORT
(a) Install the rear differential support to the rear differential carrier assembly with 4 new bolts.
Torque:
72 N
READ NEXT:
COMPONENTS ILLUSTRATION
*1 REAR DIFFERENTIAL CARRIER ASSEMBLY
*2 REAR NO. 1 DIFFERENTIAL SUPPORT
*3 REAR NO. 2 DIFFERENTIAL SUPPORT
- -
Tightening
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced duri
SEE MORE:
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
(a) Install a new front drive shaft hole snap ring. NOTICE: Face the end gap of the front d
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect