Toyota Camry owners & service manuals

Toyota Camry (XV70): Components

Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Axle And Differential / Rear Differential Carrier Oil Seal / Components

COMPONENTS

ILLUSTRATION

*1

REAR DIFFERENTIAL CARRIER ASSEMBLY

*2

REAR NO. 1 DIFFERENTIAL SUPPORT

*3

REAR NO. 2 DIFFERENTIAL SUPPORT

-

-

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf)

●

Non-reusable part

Do not apply lubricants to the threaded parts

-

-

ILLUSTRATION

*1

DIAPHRAGM OIL SEAL

*2

TRANSMISSION COUPLING ASSEMBLY

*3

TRANSMISSION COUPLING CONICAL SPRING WASHER

*4

TRANSMISSION COUPLING SHIM

*5

4WD LINEAR SOLENOID

*6

YOKE

*7

SNAP RING

*8

O-RING

*9

REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY

*10

REAR DIFFERENTIAL DRAIN PLUG

*11

GASKET

*12

REAR DIFFERENTIAL FILLER PLUG

N*m (kgf*cm, ft.*lbf): Specified torque

●

Non-reusable part

MP grease

-

-

    READ NEXT:

     Replacement

    REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced duri

     Rear Differential Side Gear Shaft Oil Seal

    ComponentsCOMPONENTS ILLUSTRATION *1 REAR DRIVE SHAFT OIL SEAL LH - - ● Non-reusable part MP grease ReplacementREPLACEMENT CAUTION / NOTICE / HINT

     Steering Knuckle

    ComponentsCOMPONENTS ILLUSTRATION *1 FRONT LOWER BALL JOINT ASSEMBLY *2 STEERING KNUCKLE *3 FRONT AXLE HUB SUB-ASSEMBLY *4 FRONT DISC BRAKE DUST COVER *5

    SEE MORE:

     Removal

    REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL LH Click here 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH HINT: Use the same procedure as for the RH side. Click here 3. REMOVE FRONT FENDER LINER LH HINT: Use the same procedure as for the RH side. Click here 4. REMOVE COOL AIR INTAKE

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) (a) Install the flow shutting valve (No. 1 water by-pass hose) with the bolt. Torque: 19 N·m {194 kgf·cm, 14 ft·lbf} (b) Connect the flow shutting valve connector. (c) Connect the flow shutting valve (No. 1 wa

    © 2023-2026 Copyright www.tocamry.com