Toyota Camry (XV70): Rear Differential Carrier Assembly
READ NEXT:
COMPONENTS ILLUSTRATION
*1 REAR DIFFERENTIAL CARRIER ASSEMBLY
*2 WIRE HARNESS CLAMP BRACKET
*3 REAR UPPER DIFFERENTIAL MOUNT STOPPER
*4 REAR LOWER DIFFERENTIAL MO
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r
DISASSEMBLY CAUTION / NOTICE / HINT
NOTICE: Before installation of each part, thoroughly clean and dry it. Then apply gear oil to it. Do not use alkaline chemicals to clean aluminum parts, rubber pa
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below. Necessary Procedures After Parts Re
ReplacementREPLACEMENT CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE COURTESY LIGHT ASSEMBLY
Click here 2. REMOVE COURTESY LIGHT BULB
(a) Using a screwdriver with its tip wrapped with prote