Toyota Camry (XV70): Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
Steps 10 to 17 are temporary reassembly procedures for adjustment purposes.
PROCEDURE
1. INSTALL STRAIGHT PIN
(a) Using a plastic-faced hammer, install the 4 straight pins to the rear differential carrier sub-assembly.
|
*a | 8.0 to 9.0 mm (0.315 to 0.354 in.) |
- | - |
2. INSTALL REAR DIFFERENTIAL BREATHER PLUG OIL DEFLECTOR
| (a) Using a 5 mm socket hexagon wrench, install the rear differential breather plug oil deflector with the 2 bolts. Torque: 5.0 N |
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DIFFERENTIAL SUPPORT
(a) Install the rear differential support to the rear differential carrier assembly with 4 new bolts.
Torque: 72 N
Components
COMPONENTS ILLUSTRATION
*1 REAR DIFFERENTIAL CARRIER ASSEMBLY
*2 REAR NO. 1 DIFFERENTIAL SUPPORT
*3 REAR NO. 2 DIFFERENTIAL SUPPORT
- -
Tightening
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY
(a) Check for looseness. (1) Lift up the vehicle. (2) Move the front lower No. 1 suspension arm sub-assembly up and down by hand with a force of 294 N (30 kgf) or more to check that there is no looseness at the front
Linear Solenoid Power Supply System Malfunction (C120C)
DESCRIPTION This DTC is output by the 4WD ECU assembly if a malfunction occurs in the linear solenoid power supply system.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C120C Linear Solenoid Power Supply System Malfunction
When the 4WD relay is on, t
© 2023-2026 Copyright www.tocamry.com
