Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Suspension / Front Suspension / Front Lower Ball Joint / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY
(a) Secure the front axle assembly in a vise using aluminum plates.
NOTICE:
Do not overtighten the vise.
(b) Install the front lower ball joint assembly to the front axle assembly with the nut.
Torque:
133 N
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*A for A25A-FKS
*B for 2GR-FKS
*1 FRONT FENDER APRON SEAL LH
*2 FRONT FLOOR COVER LH
*3 FRONT WHEEL OPENING EXTENSION PAD LH
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during f
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*1 CLEARANCE WARNING ECU ASSEMBLY
*2 ECU INTEGRATION BOX RH
*3 LOWER INSTRUMENT PANEL SUB-ASSEMBLY
- -
N*m (kgf*cm, ft.*lbf): Specified torque
- -
Power Source Circuit
DESCRIPTION This circuit provides power to operate the blind spot monitor sensor. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (BLIND SPOT MONIT
© 2023-2026 Copyright www.tocamry.com
