Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Exterior Panels / Trim / Name Plate / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
When installing the name plates or luggage compartment door emblem, heat the luggage compartment door panel and name plates using a heat light.
Heating Temperature|
Item | Temperature |
|---|---|
|
Luggage Compartment Door Panel |
40 to 60 |
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*A for Single Type
*B for Dual Type
*1 REAR BUMPER ASSEMBLY
*2 REAR COMBINATION LIGHT COVER LH
*3 REAR COMBINATION LIGHT
Removal
REMOVAL CAUTION / NOTICE / HINT
HINT: If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system
SEE MORE:
Throttle/Pedal Position Sensor/Switch "D" Circuit Short to Battery (P212012,P212014,P21201C,P21201F,P212099,P212512,P212514,P21251F,P21382B)
DESCRIPTION
HINT:
This Electronic Throttle Control System (ETCS) does not use a throttle cable.
These DTCs relate to the accelerator pedal position sensor.
The accelerator pedal position sensor is built into the accelerator pedal sensor assembly and has 2 sensor circuits: VPA (main) a
Smart key system
The following operations can be performed simply by carrying
the electronic key on your person, for example in your pocket.
(The driver should always carry the electronic key.)
Locks and unlocks the doors
Opens the trunk
Starts the engine
■Antenna location
Antennas outside the c
© 2023-2026 Copyright www.tocamry.com
