Toyota Camry (XV70): Rear Bumper
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*A for Single Type
*B for Dual Type
*1 REAR BUMPER ASSEMBLY
*2 REAR COMBINATION LIGHT COVER LH
*3 REAR COMBINATION LIGHT
Removal
REMOVAL CAUTION / NOTICE / HINT
HINT: If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR CENTER ULTRASONIC SENSOR (w/ Parking Support Brake System)
Click here HINT: Use the same procedure for the RH side and LH side.
2. REMOVE REAR CORNER ULTRA
SEE MORE:
Slip Indicator Light Remains ON
DESCRIPTION This procedure is for troubleshooting when the slip indicator light remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication.
The slip indicator light blinks during VSC
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT WIPER RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition Specified Condition
3 - 5 Battery voltage not applied betw
© 2023-2026 Copyright www.tocamry.com
