Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY
(a) for Type A:
(1) Connect the connector.
(2) Engage the 2 guides.
(3) Engage the 2 claws to install the side turn signal light assembly.
(b) for Type B:
(1) Connect the connector to install the side turn signal light assembly.
2. INSTALL OUTER MIRROR HOLE COVER ASSEMBLY (for Type A)
w/o Panoramic View Monitor System:
Click here .gif)
3. INSTALL OUTER MIRROR HOLE COVER WITH SIDE TELEVISION CAMERA ASSEMBLY (for Type A)
w/ Panoramic View Monitor System:
Click here
4. INSTALL OUTER MIRROR COVER (for Type A)
Click here
5. INSTALL OUTER MIRROR (for Type A)
Click here
6. INSTALL VISOR HOUSING (for Type B)
Click here
7. INSTALL OUTER MIRROR COVER (for Type B)
Click here
8. INSTALL OUTER MIRROR (for Type B)
Click here
9. PERFORM CALIBRATION (w/ Panoramic View Monitor System)
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
*2 STOP LIGHT SWITCH ASSEMBLY
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the A81 stop light switch assembly connector.
(b) Measure the voltage and resistance on the wire harness
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
Click here 2. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Click here
3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Click here
4. INSTALL SHIFT LOCK RELEASE BUTTON COVER
Click here 5. INST
Wiper and Washer Switch Circuit
DESCRIPTION The condition of the windshield wiper switch assembly is detected and sent to the steering sensor in this circuit. WIRING DIAGRAM
PROCEDURE
1. READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON.
(c) Turn the Te
