Toyota Camry (XV70): Stop Light Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
*2 STOP LIGHT SWITCH ASSEMBLY
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the A81 stop light switch assembly connector.
(b) Measure the voltage and resistance on the wire harness
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
2. REMOVE STOP LIGHT SWITCH ASSEMBLY
(a) Disconnect the connector.
(b) Tu
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CLEARANCE WARNING ECU ASSEMBLY
(a) Disconnect the R39 clearance warning ECU assembly connector.
(b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
Terminal No. (Symbol) Terminal Description
Condit
Fail-safe Chart
FAIL-SAFE CHART If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.
DTC Code Component
Fail-Safe Operation Fail-Safe Deactivation Condition
P001100 P001107 P001500 P002100 P002107
P00
© 2023-2026 Copyright www.tocamry.com
