Toyota Camry owners & service manuals

Toyota Camry (XV70): Parts Location

PARTS LOCATION

ILLUSTRATION

*1

FUEL SENDER GAUGE ASSEMBLY

*2

FUEL PUMP (for Low Pressure)

*3

FUEL PUMP CONTROL ECU

*4

FUEL TANK ASSEMBLY

*5

FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

*6

FUEL MAIN VALVE ASSEMBLY (for Low Pressure)

*7

FUEL MAIN VALVE ASSEMBLY (for High Pressure)

*8

ECM

*9

ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY

- EFI MAIN NO. 2 RELAY

- EFI MAIN NO. 2 FUSE

- INJ FUSE

-

-

ILLUSTRATION

*1

FUEL INJECTOR ASSEMBLY (for Port Injection)

*2

FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY) (for Low Pressure)

*3

FUEL PUMP ASSEMBLY (for High Pressure)

*4

FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH) (for High Pressure)

*5

FUEL INJECTOR ASSEMBLY (for Direct Injection)

-

-

    READ NEXT:

     System Diagram

    SYSTEM DIAGRAM FUEL FLOW DIAGRAM *A for Direct Injection - - *1 Fuel Injector Assembly *2 Throttle Body with Motor Assembly *3 Fuel Pressure Sensor (Fue

     On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK (a) Check fuel pump operation. (1) Connect the Techstream to the DLC3. (2) Turn the engine switch on (IG).

     Fuel Tank

    SEE MORE:

     Horn

    ComponentsCOMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 HIGH PITCHED HORN ASSEMBLY *3 LOW PITCHED HORN ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE COOL AIR INTAKE DUC

     Body

    BODY TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY (a) If necessary, tighten the bolts and nuts on the chassis parts listed below. Front axle and suspension Drivetrain Rear axle and suspension Brake system Engine mounts Other chassis parts (b) If necessary, tighten the bo

    © 2023-2026 Copyright www.tocamry.com