Toyota Camry (XV70): Portable Player cannot be Registered
CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assembly, even if the portable audio player itself can play files.
Click here .gif)
PROCEDURE
| 1. |
CHECK THAT PORTABLE PLAYER IS "Bluetooth" AUDIO COMPATIBLE |
(a) Check if the portable player is "Bluetooth" audio compatible.
|
Result | Proceed to |
|---|---|
|
The portable player is "Bluetooth" audio compatible. |
A |
| The portable player is not "Bluetooth" audio compatible. |
B |
| B |
.gif) | USE A "Bluetooth" AUDIO COMPATIBLE PORTABLE PLAYER |
|
.gif)
| 2. |
CHECK CONNECTION PROCEDURE OF CONNECTED DEVICE |
(a) Referring to Owner's Manual, correctly register the portable player.
(b) Check that the portable player has been registered as a connected device.
HINT:
The portable player cannot be registered under any of the following conditions:
- The A2DP (Advanced Audio Distribution Profile) is not used when registering a cellular phone.
- A different portable player registration remains in the radio and display receiver assembly.
- A different radio and display receiver assembly registration remains in the portable player.
- The portable player is off.
OK:
The portable player has been registered as a connected device.
| OK | | END |
|
| 3. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check if the portable player can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
OK:
The portable player can be registered.
| NG | | MALFUNCTION IN PORTABLE PLAYER |
|
| 4. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Place the portable player close to the radio and display receiver assembly.
(c) Check that the portable player can be registered as a connected device.
OK:
The portable player can be registered.
| OK | | END |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
READ NEXT:
USB Audio System Recognition/Play Error
DESCRIPTION When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by
Black Screen
PROCEDURE
1. CHECK DISPLAY SETTING
(a) Check that the display is not in screen off mode. OK: The display setting is not in screen off mode.
NG
CHANGE SCREEN TO SCREEN ON MODE
Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION for Automatic Sound Levelizer (ASL):
This circuit is necessary for the Automatic Sound Levelizer (ASL) built into the radio and display receiver assembly.
The Automatic Sound Leveli
SEE MORE:
Motor Control Relay Stuck ON (B2345)
DESCRIPTION This DTC will be stored if the operation of the sliding roof or roof sunshade is suspended and a pulse input of 10 Hz or more is detected when the motor relay is off. Sliding Roof
DTC No. Detection Item
DTC Detection Condition
Trouble Area
B2345 Motor Cont
HO2S Heater Control Circuit Bank 1 Sensor 2 Circuit Short to Battery (P003612,P003614,P005612,P005614,P014118,P016118,P102A9E,P105A9E)
DESCRIPTION Refer to DTC P013611. Click here
HINT:
When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the engine switch is turned off.
The heated oxygen sensor heater cir
