Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (starting) / Starter / Installation
INSTALLATION
PROCEDURE
1. INSTALL STARTER ASSEMBLY
(a) Install the starter assembly with the 2 bolts.
Torque:
46 N·m {469 kgf·cm, 34 ft·lbf}
(b) Connect the engine wire to the terminal 30 with the nut.
Torque:
9.8 N·m {100 kgf·cm, 87 in·lbf}
(c) Close the terminal cap.
(d) Connect the starter assembly connector.
2. INSTALL BATTERY CLAMP SUB-ASSEMBLY
Click here
.gif)
3. INSTALL ECM
Click here
4. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Click here
5. INSTALL INLET AIR CLEANER ASSEMBLY
Click here
6. INSTALL V-BANK COVER SUB-ASSEMBLY
Click here
7. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
8. INSTALL BATTERY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
*2 INLET AIR CLEANER ASSEMBLY
*3 BATTERY CLAMP SUB-ASSEMBLY
*4 COOL AIR INTAKE DUCT SEAL
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced starter a
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
(a) Remove the nut and disconnect the field coil lead wire from the magnet starter switch assembly.
(b) Wh
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Audio and Visual System
DTC No. Detection Item
Link B1324
Lost Communication with Meter
B1325 Lost Communication with HUD
B1551 HD Radio Tuner Malfunction
B1579 Voice Recognition Microphone
Zero Point Calibration of Steering Angle Sensor Initialization Malfunction (X208A)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X208A Zero Point Calibration of Steering Angle Sensor Initialization Malfunction
History of failure in acquiring steering angle zero point even after the vehicle is driven in a straight line at a vehicle spe
© 2023-2026 Copyright www.tocamry.com
