Toyota Camry owners & service manuals

Toyota Camry (XV70): Starter

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE *2 INLET AIR CLEANER ASSEMBLY *3 BATTERY CLAMP SUB-ASSEMBLY *4 COOL AIR INTAKE DUCT SEAL

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced starter a

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY (a) Remove the nut and disconnect the field coil lead wire from the magnet starter switch assembly. (b) Wh

SEE MORE:

 Inspection

INSPECTION PROCEDURE 1. INSPECT HEADLIGHT ASSEMBLY LH (for Bulb Type Turn Signal Light) *a Component without harness connected (Headlight Assembly LH) (a) Apply battery voltage to the headlight assembly LH and check that the Lo/Hi beam shade operates. OK: Condition

 Brake Pressure Control Solenoid "A" Control Circuit Short to Battery (C13C012,...,C13C949)

DESCRIPTION The ABS solenoid relay and master cylinder cut solenoid valves are built into the brake actuator assembly. Depending on the operating conditions, the master cylinder cut solenoid valves regulate the brake fluid pressure generated by the pump motor. When this DTC is stored, the fail-s

© 2023-2026 Copyright www.tocamry.com