Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | BATTERY |
*2 | NEGATIVE BATTERY TERMINAL |
|
*3 | POSITIVE BATTERY TERMINAL |
*4 | NO. 2 BATTERY CLAMP |
|
*5 | BATTERY TERMINAL CAP |
- | - |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
.png) |
N*m (kgf*cm, ft.*lbf): Specified torque |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the
Installation
INSTALLATION PROCEDURE 1. INSTALL BATTERY
(a) Install the battery to the vehicle. (b) Install the No. 2 battery clamp with the bolt to the battery clamp sub-assembly.
Torque: 18.5 N
SEE MORE:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT MAGNETIC CLUTCH RELAY (for 2GR-FKS)
*a Component without harness connected (Magnetic Clutch Relay)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection C
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION
When troubleshooting OBD II (On-Board Diagnostics) vehicles, the Techstream (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read.
OBD II regulation
© 2023-2026 Copyright www.tocamry.com
