Toyota Camry (XV70): Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected:
|
System Name | See Procedure |
|---|---|
|
Lane Tracing Assist System |
|
|
Pre-collision System | |
|
Parking Assist Monitor System | |
|
Panoramic View Monitor System |
HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM
NOTICE:
This vehicle is equipped with a Supplemental Restraint System (SRS). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident.
Before servicing (including inspection, replacement, removal and installation of parts), be sure to read the precautionary notices for Supplemental Restraint System.
Click here .gif)
IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression | Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK | Off (Lock) |
|
Ignition Switch ACC |
ACC | On (ACC) |
|
Ignition Switch ON |
ON | On (IG) |
|
Engine Start | START |
On (Start) |
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 STEERING HEATER SWITCH
*2 STEERING WHEEL ASSEMBLY
*3 NO. 6 RELAY BLOCK
- STRG HTR RELAY
*4 SPIRAL CABLE SUB-ASSEMBLY
System Diagram
SYSTEM DIAGRAM SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION HEATED STEERING WHEEL SYSTEM
(a) The steering heater warms up the steering wheel when the steering heater switch is turned on.
(b) The steering heater uses a control thermosta
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH
(a) Install a new rear drive shaft inboard joint shaft snap ring LH. 2. INS
Components
COMPONENTS ILLUSTRATION
*1 FLOW SHUTTING VALVE (WATER BY-PASS HOSE ASSEMBLY)
*2 VACUUM HOSE
*3 ENGINE WIRE HARNESS
*4 OUTLET HEATER HOSE
*5 INLET HEATER HOSE
*6 NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY
*7 WATER HOSE CLAMP BRACKET
-
