Toyota Camry (XV70): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
If DTCs are not output but the malfunction persists, use the following table to determine which circuits to inspect for each problem symptom.
HINT:
Refer to each inspection procedure for related problem symptoms.
Vehicle Stability Control System|
Symptom | Suspected Area |
Link |
|---|---|---|
| ABS warning light abnormal (Remains on) |
Refer to the procedure for "ABS Warning Light Remains ON" |
|
|
ABS warning light abnormal (Does not come on) |
Refer to the procedure for "ABS Warning Light does not Come ON" |
|
|
Brake system warning light (red indicator) abnormal (Remains on) |
Refer to the procedure for "Brake Warning Light Remains ON" |
|
|
Brake system warning light (red indicator) abnormal (Does not come on) |
Refer to the procedure for "Brake Warning Light does not Come ON" |
|
|
Brake hold standby indicator light abnormal |
Refer to the procedure for "Brake Hold Standby Indicator Light Circuit" |
|
|
Brake hold operated indicator light abnormal |
Refer to the procedure for "Brake Hold Operated Indicator Light Circuit" |
|
|
Slip indicator light abnormal (Remains on) |
Refer to the procedure for "Slip Indicator Light Remains ON" |
|
|
Slip indicator light abnormal (Does not come on) |
Refer to the procedure for "Slip Indicator Light does not Come ON" |
|
|
TRAC does not operate | Refer to the procedure for "TRAC does not Operate" |
|
|
Excessive brake pedal travel (No fluid leaks and no air in system) |
Refer to the procedure for "Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)" |
|
|
ABS operates before necessary when braking |
Refer to the procedure for "ABS Operates Before Necessary When Braking" |
|
|
VSC does not operate or VSC does not operate correctly |
Refer to the procedure for "VSC does not Operate or VSC does not Operate Correctly" |
|
|
Brake actuator operation sound is loud during initial check |
Refer to the procedure for "Brake Actuator Operation Sound is Loud during Initial Check" |
|
|
VSC OFF switch abnormal |
Refer to the procedure for "VSC OFF Switch Circuit" |
|
.gif)
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU TERMINALS OF ECU
*a Component without harness connected
(Skid Control ECU (Brake Actuator Assembly))
- -
HINT:
As a waterproof connector is used for th
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the Techstream to the vehicle and readin
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK (a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON.
(d) Turn the Techstream on. (e) Read the DTCs following th
SEE MORE:
Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range (C05201C)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
When the skid control ECU (brake actuator assembly) detects an abnormal acceleration sensor (airbag sensor assembly) signal, or the control value calculated using the accelerat
Adjusting the set speed - Dynamic radar cruise
control
Adjusting the set speed by the switch
To change the set speed, press the "+ RES" or "- SET" switch until the
desired set speed is displayed.
Increases the speed
Decreases the speed
Fine adjustment: Press the switch.
Large adjustment: Press and hold
the switch to change the speed,
