Toyota Camry (XV70): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses related to this system before inspecting the suspected areas below.
|
Symptom | Suspected Area |
Link |
|
Cooling fan does not operates |
Engine coolant temperature sensor |
|
|
EFI-MAIN NO. 1 Relay |
|
|
Cooling fan circuit |
|
|
Fan with motor assembly |
- |
| ECM |
|
|
Cooling fan does not stop (continues to operates) |
Engine coolant temperature sensor |
|
|
Cooling fan circuit |
|
|
Fan with motor assembly |
- |
| ECM |
|
|
Cooling fan speed does not change |
Cooling fan circuit |
|
|
Fan with motor assembly |
- |
| ECM |
|
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT COOLING FAN SYSTEM CAUTION: To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fan when ins
DESCRIPTION The ECM calculates an appropriate cooling fan speed based on the engine coolant temperature, air conditioning switch status, refrigerant pressure, engine speed and vehicle speed, and sends
On-vehicle InspectionON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
CAUTION: Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during mass air flow meter sub-assembly removal/installation are shown below. Necessary Procedures After Part
DESCRIPTION Refer to DTC C050012 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C05001F Left Front Wheel Speed Sensor Circuit Intermittent
The speed sensor signal is excessively noisy.
The calculated change in wheel speed is more