Toyota Camry (XV70): Problem Symptoms Table
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Mirror (ext) / Power Mirror Control System / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
If the battery voltage is low, the mirror heater function may not operate. In this case, check the Data List item "Battery Control Count (Body ECU)".
Click here .gif)
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom | Suspected Area |
Link |
|---|---|---|
|
Electrical remote control mirror does not operate |
Outer mirror switch assembly |
|
|
Outer rear view mirror assembly LH |
| |
|
Outer rear view mirror assembly RH |
| |
|
Wire harness or connector |
- | |
| Mirror heater does not operate |
Proceed to "Mirror Heater does not Operate with Rear Defogger Switch" |
|
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
Click here CHECK AIR CONDITIONING CONTROL ASSEMBLY
Click here
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3.
Click here INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage. Standard Voltage: 11 to 14 V
If the voltage is below 11 V, recharge or r
Data List / Active Test
DATA LIST / ACTIVE TEST ACTIVE TEST HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive f
SEE MORE:
Destination Information Undefined (C1AB8)
DESCRIPTION This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced. Blind Spot Monitor Master
DTC No. Detection Item
DTC D
Panoramic moon roof
Use the overhead switches to operate the panoramic moon roof
and electronic sunshade.
Opening and closing the electronic sunshade
Opens the electronic sunshade
Slide and hold the switch
backward. The electronic sunshade
will fully open automatically.*
Closes the electronic sunshade
© 2023-2026 Copyright www.tocamry.com
