Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

INSPECTION

CAUTION / NOTICE / HINT

NOTICE:

  • When using a vise, place aluminum plates between the part and vise.
  • When using a vise, do not overtighten it.

PROCEDURE

1. INSPECT REAR DRIVE SHAFT ASSEMBLY

(a) Check that there is no excessive play in the radial direction of the outboard joint.

(b) Check that the inboard joint slides smoothly in the thrust direction.

(c) Check that there is no excessive play in the radial direction of the inboard joint.

(d) Check the boots for damage.

(e) Check whether the drive shaft dimension (A) is within specification.

Length (A):

749.1 to 759.1 mm (2.46 to 2.49 ft.)

NOTICE:

Keep the drive shaft assembly level during inspection.

If the boots are stretched or contracted, correct them.

    READ NEXT:

     Reassembly

    REASSEMBLY CAUTION / NOTICE / HINT NOTICE: When using a vise, place aluminum plates between the part and vise. When using a vise, do not overtighten it. HINT: Use the same procedure

     Installation

    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR DRIVE SHAFT INBOARD JO

     Gf1a (transfer / 4wd / Awd)

    SEE MORE:

     Removal

    REMOVAL PROCEDURE 1. PRECAUTION NOTICE: When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur: A commun

     Luggage Compartment Door Lock

    ComponentsCOMPONENTS ILLUSTRATION *1 LUGGAGE COMPARTMENT DOOR COVER *2 LUGGAGE COMPARTMENT DOOR INSIDE HANDLE *3 LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY *4 LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY *5 LUGGAGE COMPARTMENT DOOR LOCK - - N*

    © 2023-2026 Copyright www.tocamry.com