Toyota Camry (XV70): Rear Drive Shaft Assembly
READ NEXT:
COMPONENTS ILLUSTRATION
*1 REAR DRIVE SHAFT ASSEMBLY LH
*2 REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH
*3 REAR DIFFERENTIAL CARRIER ASSEMBLY
- -
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r
DISASSEMBLY CAUTION / NOTICE / HINT
NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
HINT:
Use the same procedur
SEE MORE:
GENERAL INFORMATION GENERAL DESCRIPTION (a) This manual is written in accordance with SAE J2008.
(b) Repair operations can be separated mainly into the following 3 processes:
(1) Diagnosis (2) Removing/Installing, Replacing, Disassembling/Reassembling, Checking and Adjusting
(3) Final Inspecti
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT: Using the Techstream to read the Data List allows the values or state