Toyota Camry owners & service manuals

Toyota Camry (XV70): Rear Side Marker Light Bulb

Replacement

REPLACEMENT

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT COVER

Click here

2. SEPARATE REAR COMBINATION LIGHT ASSEMBLY

Click here

3. REMOVE REAR SIDE MARKER LIGHT BULB

Click here

4. INSTALL REAR SIDE MARKER LIGHT BULB

Click here

5. INSTALL REAR COMBINATION LIGHT ASSEMBLY

Click here

6. INSTALL REAR COMBINATION LIGHT COVER

Click here

    READ NEXT:

     Rear Turn Signal Light Bulb

    ReplacementREPLACEMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE REAR COMBINA

     Relay

    On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT H-LP LH RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Con

     Side Turn Signal Light Assembly

    SEE MORE:

     System Voltage Circuit Short to Ground or Open (P056014)

    MONITOR DESCRIPTION The battery supplies electricity to the ECM even when the engine switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the memory is cleared and the ECM determines th

     Removal

    REMOVAL PROCEDURE 1. REMOVE LUGGAGE COMPARTMENT DOOR COVER Click here 2. REMOVE REAR SPOILER (a) Apply protective tape around the rear spoiler as shown in the illustration. Protective Tape (b) except TRD: (1) Remove the 2 bolts. (2) Separate

    © 2023-2026 Copyright www.tocamry.com