Toyota Camry (XV70): Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL RING PIN
| (a) Install the 2 ring pins to the front oil pump cover sub-assembly. |
|
2. INSTALL FRONT OIL PUMP BODY
| (a) Install the front oil pump body to the front oil pump cover sub-assembly. |
|
3. INSTALL FRONT OIL PUMP DRIVEN GEAR
| (a) Coat the front oil pump driven gear with Toyota Genuine ATF WS and install it to the front oil pump body. |
|
4. INSTALL FRONT OIL PUMP DRIVE GEAR
(a) Coat the front oil pump drive gear with Toyota Genuine ATF WS and install it to the front oil pump body.
5. INSTALL STATOR SHAFT ASSEMBLY
| (a) Install the stator shaft assembly to the front oil pump body with the 5 bolts.
Torque: 9.1 N |
READ NEXT:
COMPONENTS ILLUSTRATION
*1 BATTERY CLAMP SUB-ASSEMBLY
- -
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
*1 TRANSMISSION CONTROL CA
ON-VEHICLE INSPECTION PROCEDURE
1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel.
CAUTION:
Make sure to apply the parking brake and chock a wheel before performing this pr
SEE MORE:
SYSTEM DESCRIPTION DESCRIPTION (a) Safety Connect performs ACN (Automatic Collision Notification), manual emergency calling, stolen vehicle tracking and roadside assistance service by, audio and data communications between the vehicle and call center through a cellular phone network. As shown in the
DIAGNOSTIC TROUBLE CODE CHART Safety Connect System
DTC No. Detection Item
Link B153711
Telephone Sub Antenna Circuit Short to Ground
B153713 Telephone Sub Antenna Circuit Open
B157011 Indicator (Red) Circuit Short to Ground