Toyota Camry owners & service manuals

Toyota Camry (XV70): Right Rear Wheel Speed Sensor Signal Stuck High (C051224)

Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System (w/ Electric Parking Brake System) / Right Rear Wheel Speed Sensor Signal Stuck High (C051224)

DESCRIPTION

Refer to DTC C051212

Click here

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C051224

Right Rear Wheel Speed Sensor Signal Stuck High

The speed sensor signal is not within the specified range for 5 seconds or more.
  • Rear speed sensor RH (rear axle hub and bearing assembly RH)*1
  • Rear speed sensor RH*2

*1: for 2WD

*2: for AWD

CAUTION / NOTICE / HINT

NOTICE:

After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click here

PROCEDURE

1.

CHECK VEHICLE

(a) Check the vehicle specification.

Result

Proceed to

for 2WD

A

for AWD

B
A

REPLACE REAR AXLE HUB AND BEARING ASSEMBLY RH

B

REPLACE REAR SPEED SENSOR RH

    READ NEXT:

     Right Rear Wheel Speed Sensor Internal Electronic Failure (C051249)

    DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC

     Multi-axis Acceleration Sensor Module "A" Missing Calibration (C051D54)

    DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) receives signals from the yaw

     Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range (C05201C)

    DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. When the skid control ECU (brake actuator assembly) detects an abnormal acce

    SEE MORE:

     Rocker Panel Moulding

    ComponentsCOMPONENTS ILLUSTRATION *1 FRONT ROCKER PANEL MOULDING END COVER *2 ROCKER PANEL MOULDING *3 GROMMET *4 CLIP ● Non-reusable part - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the

     No Response from ID BOX (B2789)

    DESCRIPTION This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for 10 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B2789 No Response from ID BOX N

    © 2023-2026 Copyright www.tocamry.com