Toyota Camry (XV70): Steering Angle Sensor Module Component Internal Failure (C052696)
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System (w/o Electric Parking Brake System) / Steering Angle Sensor Module Component Internal Failure (C052696)
DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering angle sensor.
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C052696 | Steering Angle Sensor Module Component Internal Failure |
With the +BS terminal voltage between 9.6 and 16.5 V, a steering angle sensor internal malfunction signal is received from the steering angle sensor. |
Steering angle sensor |
PROCEDURE
| 1. |
REPLACE STEERING ANGLE SENSOR |
(a) Replace the steering angle sensor.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
ABS Pump Motor Control Circuit Short to Ground (C052C11,C052C13,C052F14,C142719)
DESCRIPTION The ABS motor relay is built into the brake actuator assembly.
When the skid control ECU (brake actuator assembly) operates ABS, TRAC, VSC or brake assist, the ABS motor relay turns ON a
ABS Pump Motor Control Internal Electronic Failure (C052C49)
DESCRIPTION The ABS motor relay and pump motor are built into the brake actuator assembly.
If the skid control ECU (brake actuator assembly) detects a malfunction in the drive circuit of the pump mo
Brake Pressure Sensor "A" Circuit Voltage Out of Range (C05401C,C054028,C054049)
DESCRIPTION The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.
DTC No. Detection Item
DTC Detection Condition Trouble Area
SEE MORE:
Operation Check
OPERATION CHECK TOYOTA ENTUNE APP SUITE CONNECT RESET PROCEDURE
(a) Duplicate the problem symptom. (b) Check for DTCs and repair the systems for which any DTCs are output.
Click here
(c) Check cellular phone compatibility.
(1) Check if the cellular phone/vehicle is compatible (Refer to ht
Pressure Sensor Circuit
DESCRIPTION Based on signals from the air conditioner pressure sensor, the air conditioning amplifier assembly controls the compressor solenoid of the compressor assembly with pulley and changes the air inlet mode between fresh and recirculation in order to protect the parts of the refrigerant cycle
© 2023-2026 Copyright www.tocamry.com
