Toyota Camry owners & service manuals

Toyota Camry (XV70): Stereo Component Amplifier Malfunction (B15A3)

Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Audio / Video / Audio And Visual System / Stereo Component Amplifier Malfunction (B15A3)

DESCRIPTION

This DTC is stored when a malfunction occurs in the stereo component amplifier assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15A3

Stereo Component Amplifier Malfunction

When any of the following conditions is met:

  • Internal power supply malfunction
  • DSP error
  • EEPROM error

Stereo component amplifier assembly

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

    READ NEXT:

     GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

    DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15C0 GPS Antenna C

     Speaker Output Short (B15C3)

    DESCRIPTION This DTC is stored when a malfunction occurs in the speakers. DTC No. Detection Item DTC Detection Condition Trouble Area B15C3 Speaker Output Short A short

     Stereo Component Amplifier Disconnected (B15D3)

    DESCRIPTION The radio and display receiver assembly and stereo component amplifier assembly are connected by the AVC-LAN communication line. DTC No. Detection Item DTC Detection Condition

    SEE MORE:

     Disassembly

    DISASSEMBLY PROCEDURE 1. REMOVE OIL PUMP RELIEF VALVE (a) Using a 27 mm socket wrench, remove the oil pump relief valve plug from the oil pump cover. (b) Remove the oil pump relief valve spring and oil pump relief valve from the valve hole. 2. REMOVE OIL PUMP COVER

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced starter assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Rep

    © 2023-2026 Copyright www.tocamry.com