DESCRIPTION
The ABS motor relay and pump motor are built into the brake actuator assembly.
If the skid control ECU (brake actuator assembly) detects a malfunction in the drive circuit of the pump motor, this DTC is stored.
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C052C49 | ABS Pump Motor Control Internal Electronic Failure |
| Skid control ECU (brake actuator assembly) |
|
Vehicle Condition | |||
|---|---|---|---|
|
Pattern 1 | Pattern 2 | ||
|
Diagnosis Condition | The system has started. |
- | ○ |
|
Malfunction Status | The skid control ECU (brake actuator assembly) detects a malfunction in the pump motor circuit. |
○ | - |
|
A short to +B is detected during the ABS motor drive circuit self test. |
- | ○ | |
|
Detection Time | - |
- | |
|
Number of Trips | 1 trip |
1 trip | |
HINT:
DTC will be output when conditions for either of the patterns in the table above are met.
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Click here
PROCEDURE
| 1. |
REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the skid control ECU (brake actuator assembly).
Click here
| NEXT | | END |
Brake Pressure Sensor "A" Circuit Voltage Out of Range (C05401C,C054028,C054049)
Brake System Control Module "A" System Internal Failure (C059704)
ECM Communication (C124A00)
Removal
Right Electric Parking Brake Actuator Control Circuit Open (C061013)