Toyota Camry owners & service manuals

Toyota Camry (XV70): Blind Spot Monitor Slave Module (C1AB7)

Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Park Assist / Monitoring / Blind Spot Monitor System / Blind Spot Monitor Slave Module (C1AB7)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AB7

Blind Spot Monitor Slave Module

The blind spot monitor sensor LH (slave) detects an internal malfunction

Blind spot monitor sensor LH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.

PROCEDURE

1.

CHECK DTC

(a) Turn the engine switch off.

(b) Turn the engine switch on (IG).

(c) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE BLIND SPOT MONITOR SENSOR LH

    READ NEXT:

     Destination Information Undefined (C1AB8)

    DESCRIPTION This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot m

     Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)

    DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. T

     Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

    DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. T

    SEE MORE:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL REAR STEREO COMPONENT SPEAKER ASSEMBLY NOTICE: Do not touch the speaker cone. (a) Connect the connector. (b) Engage the guide to temporarily install the rear stereo component speaker assembly. (c) Install the rear stereo component speaker assembly with the

     Rear Television Camera Communication Stop Mode

    DESCRIPTION Detection Item Symptom Trouble Area Rear Television Camera Communication Stop Mode Any of the following conditions are met: Communication stop for "Parking Assist Monitor System / Rear Camera" is indicated on the "Communication Bus Check" screen of the Tec

    © 2023-2026 Copyright www.tocamry.com