Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | BRAKE MASTER CYLINDER O-RING |
*2 | BRAKE MASTER CYLINDER SUB-ASSEMBLY |
|
*3 | BRAKE LINE |
*4 | CONNECTOR |
|
*5 | BRAKE BOOSTER ASSEMBLY |
- | - |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
* | For use with a union nut wrench |
|
● | Non-reusable part |
- | - |
ILLUSTRATION
|
*1 | BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY |
*2 | BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY |
|
*3 | BRAKE MASTER CYLINDER RESERVOIR STRAINER |
*4 | BRAKE MASTER CYLINDER STRAIGHT PIN |
|
*5 | MASTER CYLINDER RESERVOIR GROMMET |
*6 | BRAKE MASTER CYLINDER BODY |
|
● | Non-reusable part |
.png) |
Lithium soap base glycol grease |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during br
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE BRAKE MASTER CYLINDER STRAIGHT PIN
(a) Secure the brake master cylinder sub-assembly in a vise. NOTICE:
Place aluminum plates on the vise to prevent damage to the b
Inspection
INSPECTION PROCEDURE 1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD
NOTICE: Make the adjustment with no vacuum in the brake booster assembly. (Depress the brake pedal several times with the engine sto
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*A except 2-Pod Caliper
*B for 2-Pod Caliper
*1 FRONT AXLE ASSEMBLY
*2 FRONT AXLE SHAFT NUT
*3 FRONT DISC
*4 FRONT DISC BRAKE CALIPER ASSEMBLY
*5 FRONT DRIVE SHAFT ASSEMBLY
*6 FRONT LOWER NO. 1 SUSPENSI
Open in Bus 2 Main Bus Line
DESCRIPTION There may be an open circuit in one of the CAN main bus lines when the resistance between terminals 18 (CA4H) and 17 (CA4L) of the central gateway ECU (network gateway ECU) is 70 Ω or higher.
Symptom Trouble Area
Resistance between terminals 18 (CA4H) and 17 (CA4L) o
© 2023-2026 Copyright www.tocamry.com
