Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | ENGINE WATER PUMP ASSEMBLY |
*2 | NO. 2 IDLER PULLEY SUB-ASSEMBLY |
|
*3 | WATER PUMP PULLEY |
*4 | WATER PUMP GASKET |
|
*5 | V-RIBBED BELT |
- | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● | Non-reusable part |
|
Do not apply lubricants to the threaded parts |
- | - |
READ NEXT:
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
HINT:
Water Pump Construction Evaporation Port and Drain Plug:
*1
Evaporation Port
*2
Me
REMOVAL PROCEDURE 1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Click here 2. REMOVE V-RIBBED BELT
Click here 3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
(a) Remove the bolt and No. 2
INSTALLATION PROCEDURE 1. INSTALL ENGINE WATER PUMP ASSEMBLY
(a) Install a new water pump gasket and the engine water pump assembly with the 15 bolts.
Torque: Bolt (A) : 43 N·m {438 kgf·c
SEE MORE:
COMPONENTS ILLUSTRATION
*1 INSTRUMENT PANEL TO PEDAL BRACKET
*2 NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
*3 PARKING BRAKE PEDAL ASSEMBLY
*4 NO. 1 PARKING BRAKE CABLE ASSEMBLY
Tightening torque for "Major areas involving basic vehicle perf
TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
(a) Disconnect the MB main body ECU (multiplex network body ECU) connector.
Click here (b) Measure the voltage and resistance according to the value(s) in the table below.
HINT: Me