Toyota Camry owners & service manuals

Toyota Camry (XV70): Components

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (engine Mechanical) / Front Crankshaft Oil Seal / Components

COMPONENTS

ILLUSTRATION

*1

CRANKSHAFT PULLEY

*2

TIMING CHAIN CASE OIL SEAL

*3

CRANKSHAFT PULLEY SET BOLT

*4

V-RIBBED BELT

N*m (kgf*cm, ft.*lbf): Specified torque

●

Non-reusable part

MP grease

-

-

    READ NEXT:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during f

     Installation

    INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN CASE OIL SEAL (a) Apply MP grease to the lip of a new timing chain case oil seal. *a Oil Seal Protrusion Height

     Rear Crankshaft Oil Seal

    SEE MORE:

     Control Module Processor System Internal Failure (P060604,P060629,P06062A,P060647)

    MONITOR DESCRIPTION The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from these CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store a DTCs. DTC No. Detection Item DTC Det

     Operation Check

    OPERATION CHECK PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION HINT: The blind spot monitor beam axis confirmation is performed to confirm whether the sensor beam axis is correct, and to adjust the beam axis by using a reflector. (a) When performing the blind spot monitor beam axis confirmati

    © 2023-2026 Copyright www.tocamry.com