Toyota Camry (XV70): Rear Crankshaft Oil Seal
READ NEXT:
COMPONENTS ILLUSTRATION
*1 REAR ENGINE OIL SEAL
*2 NO. 1 CRANKSHAFT POSITION SENSOR PLATE
*3 DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
*4 REAR DRIVE PLATE SPACER
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL
(a) Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
NOTICE:
Using heig
SEE MORE:
CHECK FOR INTERMITTENT PROBLEMS CHECK FOR INTERMITTENT PROBLEMS
HINT: A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the Data List function of the Techstream.
(a) Turn the ignition switch off. (b) Connect the Techs
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Click here
3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
4. REMOVE INSTRUMENT SIDE PANEL LH Click here
5. REM