Toyota Camry owners & service manuals

Toyota Camry (XV70): Components

COMPONENTS

ILLUSTRATION

*1

REAR ENGINE OIL SEAL

*2

NO. 1 CRANKSHAFT POSITION SENSOR PLATE

*3

DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

*4

REAR DRIVE PLATE SPACER

N*m (kgf*cm, ft.*lbf): Specified torque

Non-reusable part

MP grease

Adhesive 1324

Precoated part

-

-

    READ NEXT:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r

     Installation

    INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface. NOTICE: Using heig

     2gr-fks (fuel)

    SEE MORE:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN CASE OIL SEAL (a) Apply MP grease to the lip of a new timing chain case oil seal. *a Oil Seal Protrusion Height (b) Using SST and a hammer, tap in the timing chain case oil seal until its surface is flus

     Fail-safe Chart

    FAIL-SAFE CHART If the following DTC is stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily. DTC No. Fail-safe Operation Fail-safe Deactivation Condition P161A87 Generator command is fixed. Engine switch is turned on (IG) after condition r

    © 2023-2026 Copyright www.tocamry.com