Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
.png)
|
*1 | FUEL SENDER GAUGE ASSEMBLY |
*2 | FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fu
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL SENDER GAUGE ASSEMBLY
CAUTION: Perform the inspection in a well-ventilated area. Do not perform the inspection near an open flame.
(a) Check that the float mov
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL SENDER GAUGE ASSEMBLY
(a) Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
NOTICE: Be careful
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE If DTCs are not output but the malfunction persists, use the following table to determine which circuits to inspect for each problem symptom.
HINT: Refer to each inspection procedure for related problem symptoms. Vehicle Stability Control System
Symptom Suspected Are
Pressure Control Solenoid "A" Circuit Short to Ground or Open (P074514)
DESCRIPTION Refer to DTC P074512. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P074514
Pressure Control Solenoid "A" Circuit Short to Ground or Open
While the vehicle is being driven so that gear changes occur,
© 2023-2025 Copyright www.tocamry.com
