Toyota Camry owners & service manuals

Toyota Camry (XV70): Customize Parameters

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Door / Hatch / Fuel Lid Opener System / Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE LUGGAGE COMPARTMENT DOOR OPENER SYSTEM

HINT:

The following items can be customized.

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make a note of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.

(a) Customizing with the Techstream

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Customize Setting / Others.

(5) Select the setting by referring to the table below.

Others

Tester Display

Description

Default

Setting

ECU

Trunk / Fuel Opener SW Operation Setting

Function that sets the fuel lid opener switch operation.

Short: Fuel lid open request sent when fuel lid opener switch pushed.

Long: Fuel lid open request sent when fuel lid opener switch pushed for 0.8 seconds.

Long

0:Short,1:Long

Main Body ECU (Multiplex Network Body ECU)

    READ NEXT:

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in or

     Terminals Of Ecu

    TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU) from the instrument panel j

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a

    SEE MORE:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during oil pump removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Repl

     Front seats

    Adjustment procedure Manual seat Seat position adjustment lever Seatback angle adjustment lever Vertical height adjustment lever Power seat Seat position adjustment switch Seatback angle adjustment switch Seat cushion (front) angle adjustment switch Vertical height adju

    © 2023-2026 Copyright www.tocamry.com