Toyota Camry (XV70): Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Front Camera System|
DTC No. | Detection Item |
Link |
|---|---|---|
| C10001C |
Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range |
|
|
C10051C | Control Module Internal Temperature Sensor "B" Circuit Circuit Voltage Out of Range |
|
|
C100A62 | Control Module Internal Temperature Sensor A/B Correlation Signal Compare Failure |
|
|
C1A9346 | Main Microcomputer in Front Recognition Camera Calibration/Parameter Memory Failure |
|
|
C1A9445 | Image Processing Microcomputer in Front Recognition Camera Program Memory Failure |
|
|
C1A9447 | Image Processing Microcomputer in Front Recognition Camera Watchdog/Safety MCU Failure |
|
|
C1A9487 | Image Processing Microcomputer to Main Microcomputer in Front Recognition Camera Missing Message |
|
|
C1A9500 | Image Processing Module Malfunction in Front Recognition Camera |
|
|
C1A961C | Power Supply Circuit in Front Recognition Camera Circuit Voltage Out of Range |
|
|
C1AA800 | Front Recognition Camera Optical Axis Misalignment Malfunction |
|
|
C1AAE00 | Front Recognition Camera Heater Malfunction |
|
|
U010087 | Lost Communication with ECM/PCM "A" Missing Message |
|
|
U012587 | Lost Communication with Multi-axis Acceleration Sensor Module Missing Message |
|
|
U012687 | Lost Communication with Steering Angle Sensor Module Missing Message |
|
|
U012987 | Lost Communication with Brake System Control Module Missing Message |
|
|
U014087 | Lost Communication with Body Control Module Missing Message |
|
|
U030051 | Internal Control Module Software Incompatibility Not Programmed |
|
|
U030057 | Internal Control Module Software Incompatibility Invalid/Incompatible Software Component |
|
|
U032251 | Software Incompatibility with Body Control Module Not Programmed |
|
|
U032257 | Software Incompatibility with Body Control Module Invalid/Incompatible Software Component |
|
.gif)
READ NEXT:
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.
CHECK VEHICLE CONTROL HISTORY (FRONT
Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range (C10001C,C10051C,C100A62,C1A9346,C1A9445,C1A9447,C1A9487-C1A961C)
DESCRIPTION When an internal malfunction is detected in the forward recognition camera, these DTCs are stored.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C10001
Front Recognition Camera Optical Axis Misalignment Malfunction (C1AA800)
DESCRIPTION The forward recognition camera monitors its optical axis status. If it determines that the optical axis alignment has become misaligned, it will store DTC C1AA800.
DTC No. Detectio
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
(a) Remove the nut and disconnect the field coil lead wire from the magnet starter switch assembly.
(b) While holding the magnet starter switch assembly to the repair service starter kit, remove the 2 nuts.
High Temperature Adjustment
HIGH TEMPERATURE ADJUSTMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below. Necessary Procedures After
