Toyota Camry (XV70): Front Camera System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Utility
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range (C10001C,C10051C,C100A62,C1A9346,C1A9445,C1A9447,C1A9487-C1A961C)
- Front Recognition Camera Optical Axis Misalignment Malfunction (C1AA800)
- Front Recognition Camera Heater Malfunction (C1AAE00)
- Lost Communication with ECM/PCM "A" Missing Message (U010087,U012587,U012687,U012987,U014087)
- Internal Control Module Software Incompatibility Not Programmed (U030051,U030057)
- Software Incompatibility with Body Control Module Not Programmed (U032251)
- Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)
READ NEXT:
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the c
PARTS LOCATION ILLUSTRATION
*1 FORWARD RECOGNITION CAMERA
*2 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY
*3 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
*4 EC
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below. Necessary Procedures After Par
ComponentsCOMPONENTS ILLUSTRATION
*1 DRIVE SHAFT BEARING BRACKET
*2 FRONT DRIVE SHAFT OIL SEAL LH
*3 FRONT DRIVE SHAFT OIL SEAL RH
- -
N*m (kgf*cm, ft.*lbf): Specified torque
● Non-reusable part
Do not apply lubricants