Toyota Camry (XV70): Dtc Check / Clear
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / Cruise Control / Front Camera System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTC
(a) Check for DTCs (Test Failed / Pending / Confirmed).
Chassis > Front Recognition Camera > Trouble Codes|
Techstream Display | Description |
|---|---|
|
Test Failed | Shows the malfunction judgment results during the current trip. |
|
Pending | Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.) |
|
Confirmed | Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.) |
HINT:
Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.
CLEAR DTC
(a) Clear the DTCs.
Chassis > Front Recognition Camera > Clear DTCsHINT:
DTCs and freeze frame data are cleared at the same time.
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) When a front camera system DTC is stored, the forward recognition camera stores the current vehicle (ECU or sensor) state as Freeze Frame Data.
CHECK FREEZE FRAME D
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the front camera system, the systems that use the forward recognition camera perform the fail-safe function.
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
SEE MORE:
Riding with children
Observe the following precautions when children are in the vehicle.
Use a child restraint system appropriate for the child, until the
child becomes large enough to properly wear the vehicle's seat
belt.
It is recommended that children sit in the rear seats to avoid
accidental
contact w
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the Techstream to the DLC3.
(2) Start the engine. (3) Turn the Techstream on. (4) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset. Powertrai
© 2023-2026 Copyright www.tocamry.com
