Toyota Camry (XV70): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Front Camera System
|
Symptom | Suspected Area |
Link |
| "Front Camera Low Visibility Unavailable See Owner's Manual" is displayed |
Vehicle Control History (Front Camera System) |
|
|
"Front Camera Out of Temperature Range Unavailable Wait until Normal Temperature" is displayed |
Vehicle Control History (Front Camera System) |
|
|
Vehicle Control History (Pre-collision System) |
|
|
"Front Camera Unavailable See Owner's Manual" is displayed |
Vehicle Control History (Front Camera System) |
|
|
Vehicle Control History (Pre-collision System) |
|
READ NEXT:
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) If a malfunction is detected in the forward recognition camera, the forward recognition camera stores a DTC without directly informing the driver via indicator
DTC CHECK / CLEAR CHECK FOR DTC (a) Check for DTCs (Test Failed / Pending / Confirmed). Chassis > Front Recognition Camera > Trouble Codes
Techstream Display Description
Test Fai
SEE MORE:
DESCRIPTION The skid control ECU (brake actuator assembly) sends signals such as brake request signals to the ECM. If an abnormal signal is detected, the ECM stores DTC P163081.
DTC No. Detection Item
DTC Detection Condition Trouble Area
DTC Output from
P163081 Communic
INSTALLATION PROCEDURE 1. INSTALL VSC OFF SWITCH
(a) Engage the 2 claws to install the VSC OFF switch to the No. 1 instrument panel sub-assembly.
2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY Click here
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL NO.