Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL SPARK PLUG
Click here .gif)
2. INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly.
Click here
(a) Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly with the 3 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
(b) Connect the 3 ignition coil assembly connectors.
(c) Engage the 2 wire harness clamps.
(d) Engage the 4 clamps to install the vacuum hose to the intake air surge tank assembly.
(e) Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly LH with the 3 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
(f) Connect the 3 ignition coil assembly connectors.
3. INSTALL V-BANK COVER SUB-ASSEMBLY
Click here
4. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
Click here
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 ECM
*2 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY
- INJ FUSE *3
IGNITION COIL ASSEMBLY
*4 SPARK PLUG
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*1 V-BANK COVER SUB-ASSEMBLY
*2 AIR FUEL RATIO SENSOR (for Bank 1)
*3 AIR FUEL RATIO SENSOR (for Bank 2)
- -
N*m (kgf*cm, ft.*lbf): Specified torque
* For use with SST
Right Rear Wheel Speed Sensor Internal Electronic Failure (C051249)
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC is stored.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C05124
