Toyota Camry (XV70): Ignition Coil And Spark Plug
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (engine Control) / Ignition Coil And Spark Plug
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 IGNITION COIL ASSEMBLY
*2 SPARK PLUG
*3 V-BANK COVER SUB-ASSEMBLY
*4 VACUUM HOSE
N*m (kgf*cm, ft.*lbf): Specified torque
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during i
Installation
INSTALLATION PROCEDURE 1. INSTALL SPARK PLUG
Click here 2. INSTALL IGNITION COIL ASSEMBLY
HINT: Perform "Inspection After Repair" after replacing an ignition coil assembly.
Click here
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
(a) Disconnect the V2 sliding roof ECU (sliding roof drive gear sub-assembly) connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON. (c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body or Smart Key* / Trouble Codes.
*: w/ Smart Key System
Body Electrical > Main Body > Trouble
© 2023-2026 Copyright www.tocamry.com
