Toyota Camry owners & service manuals

Toyota Camry (XV70): Differential Oil

Components

COMPONENTS

ILLUSTRATION

*1

REAR DIFFERENTIAL FILLER PLUG

*2

REAR DIFFERENTIAL DRAIN PLUG

*3

GASKET

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

●

Non-reusable part

Replacement

REPLACEMENT

PROCEDURE

1. DRAIN DIFFERENTIAL OIL

(a) Stop the vehicle on a level surface.

(b) Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.

(c) Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket.

(d) Drain the differential oil.

(e) Install a new gasket and the rear differential drain plug.

Torque:

39 N

    READ NEXT:

     Front Brake Flexible Hose

     Components

    COMPONENTS ILLUSTRATION *1 FRONT FLEXIBLE HOSE *2 GASKET *3 BRAKE LINE *4 FRONT SPEED SENSOR *5 UNION BOLT - - Tightening torque

     Removal

    REMOVAL CAUTION / NOTICE / HINT NOTICE: If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installati

    SEE MORE:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear upper control arm assembly removal/installation are shown below. Necessary Procedures After Part

     Inspection

    INSPECTION PROCEDURE 1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disengage the clamp to disconnect the wire harness protector. *1 Wire Harness Protector (b) Disconnect the engine oil pressure switch assembly connector. (c) Start the engine.

    © 2023-2026 Copyright www.tocamry.com