Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | FRONT FLEXIBLE HOSE |
*2 | GASKET |
|
*3 | BRAKE LINE |
*4 | FRONT SPEED SENSOR |
|
*5 | UNION BOLT |
- | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
* | For use with a union nut wrench |
|
● | Non-reusable part |
- | - |
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT
NOTICE: If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installati
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
Because the left and right front flexible hoses are not interchangeable, verify the part number when installing the front flexible hoses.
When r
SEE MORE:
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
(a) Install a new front drive shaft hole snap ring. NOTICE: Face the end gap of the front d
ADJUSTMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after completing the rear wheel alignment procedure are shown below. Necessary Procedures After Procedure Performed
Replaced Part or Performed Procedu